Race Duration -

-Qualifying                   1 minute/No Byes
-Consies                     2 minute brackets/1 minute lane change
-Heats                         2 minute brackets/1 minute lane change
-Quarter Final             2 minute brackets/1 minute lane change
-Semi Final                  2 minute brackets/1 minute lane change
-Final                          3 minute brackets/2 minute lane change

Body -
Permitted bodies are: - GTP
PSE / GT
PSE 70506 Intrepid SS
PSE 70519 Ultimate Intrepid
PSE 70522 Courage W.S.C.
PSE 70523 R & S W.S.C
JK 7014B Ultimate Peugeot
OS-062U/Ultimate 333
OS-065U/ BMW HS
Full Interior MUST be used

Chassis - Any.

Rear Axle -
-Any 3/32 or 1/8 solid only
-Oilite type bushings only, may be soldered or glued in place.

Gears -
-Any

Motor -
-Any Mura, Champion (Force or Xterminator) or RJR full size "C" can type setup, Koford "C" can setup allowed (no strap cans).
-Must use all original hardware including- endbell, brush hoods, buss bars. Spring posts may be substituted.
-Endbell and hardware may not be modified in any way.
-Endbell hardware screws and endbell to can mounting- screws may be added and/or substituted.
-Can may not be modified except for the following
-Notching for axle clearance.
-Removal of plating and/or paint to facilitate soldering.
-Oilite hole may be centered.
-A small hole (max 2mm) may be drilled in each side of the can to aid in gluing magnets.
-Oilite type bushings only. May be soldered and/or glued in place.
-Any full can height, single piece ceramic magnets may be used (NO Quads).
-Magnets may be shimmed, glued, radiused and polished.
-Any brushes and springs may be used.
-Shunt wire and spring insulation may be used.
-Any tagged "X-12" or "X-12+" armature with a minimum stack length of 0.350" and a minimum 50 series wound turns of 29 gauge (AWG) wire may be used.
-Minimum armature diameter 0.512".
-Armature spacers may be used.

Return