-Qualifying-
1 minute/No bye
-Consie
2 minute brackets/1 minute lane change
-Heats
2 minute brackets/1minute lane change
-Quarter Final 2 minute
brackets/1minute lane change
-Semi Final
2 minute brackets/1minute lane change
-Final
3 minute brackets/2 minute lane change
Body -
Permitted bodies are –
PSE / GT
PSE 70506 Intrepid SS
PSE 70519 Ultimate Intrepid
PSE 70522 Courage W.S.C.
PSE 70523 R & S W.S.C
JK 7014B Ultimate Peugeot
Interiors are required - PSE wing car interior permitted.
Chassis -
-Any Parma, Taiwan, Racer, Champion, RJR or Slot Works pressed steel Group
10 type chassis may be used. All original dimensions, mounting points and basic
configuration must be retained with the following exceptions.
-Plating may be removed to facilitate soldering to chassis parts.
-Chassis may be braced with wire and weight may be added.
-Rear axle tube and/or motor brace may be added. Motor may be soldered in position.
-Rear axle height may be altered provided no material, other than plating, is removed from
chassis.
-Brass "pin" tube to a maximum length of 15mm may be fitted to each original
body-mounting hole and the body may be mounted with straight pins. Pin tube on RJR #792
chassis if located in pintube option must retain stock length of 78mm.
-Front axle may be soldered in place or braced with wire to prevent rotation.
-Maximum front axle diameter – 0.062".
-Front wheel retainers and spacers may be substituted and/or soldered in place.
Rear Axle -
-Any 3/32 or 1/8 solid only
-Oilite type bushings only, may be soldered or glued in place.
Gears -
-Any
Motor -
-Any Mura, Champion (Force or Xterminator) or RJR full size "C"
can type setup (no strap cans).
-Must use all original hardware including endbell, brush hoods and buss bars. Spring posts
may be substituted.
-EndbeII and hardware may not be modified in any way.
-Endbell hardware screws and endbell to can mounting screws may be added and/or
substituted
-Can may not be modified except for the following
-Notching for axle clearance.
-Removal of plating or paint to facilitate soldering.
-Oilite hole may be centered.
-A small hole (max 2mm) may be drilled in each side of the can to aid in gluing magnets
-0ilite type bushings only - May be soldered and/or glued in place.
-Any full can height, single piece ceramic magnets may be used (no quads).
-Magnets may be shimmed, glued, polished and radiused.
-Any brushed and springs may be used.
-Shunt wire and spring insulation are permitted.
-Any tagged "Super Wasp, "Super Wasp +" or RJR "Hornet" armature
with a minimum stack length of 0.350" and a minimum 60 series wound turns of 30 gauge
(AWG) wire may be used. Minimum diameter 0.512".
-Armature spacers may be used.