GROUP 10 SEDAN SPECIFICATIONS

Race Duration
-Qualifying                       1 minute/no byes
-Consie                           2 minute brackets/1minute lane change
-Heats                              2 minute brackets/1 minute lane change
-Quarter Final                  2 minute brackets/1 minute lane change 
-Semi Final                       2 minute brackets/l minute lane change
-Final                                3 minute brackets/2 minute lane change

Body –
Permitted Bodies –
Sunset / GT 'VR' Commodore (fixed and separate wing)
Sunset / GT 'AU Falcon'
Sunset 'VS' Commodore
Sunset 'EF' Falcon (fixed and separate wing)
Sunset 'EL' Falcon
Rear wings must be in place at all times during racing
Full interiors required.

Chassis
- Any Parma, Taiwan, Racer, Champion, JK or Slotworks pressed steel Group 10 type
chassis may be used. All original dimensions, mounting points and basic configuration must be retained with the following exceptions.
-Plating may be removed to facilitate soldering of chassis parts.
-Rear axle tube and/or wire motor brace may be added.
-Motor may be soldered in position.
-Rear axle height may be altered providing no material other than plating is removed from chassis
-Body tape may be used to aid chassis performance
-Front axle may be soldered in place or braced with wire to prevent rotation.
-Maximum front axle diameter - .062"
-Front wheel retainers may be substituted and/or soldered in place.

Rear Axle -
- 1/8th Solid only
- Oilite type bushings only, may be soldered or glued in place.

Gears -
Any unmodified 48D.P. Gears
Pinion size restricted to 8 or 9 teeth only.

Motor -
Parma or Slotworks standard or Super 16D setup. Midnight 2AT and Parma "rotor" adjustable timing setups permitted.
Must use all original hardware including endbell, brush hoods, buss bars and spring posts. Endbell and hardware may not be modified in any way with the exception of honing the hoods to fit "Big Foot" motor brushes.
Endbell hardware screws and endbell to can mounting screws may be added and/or substituted.
Can may not be modified except for the Following.
- Notching for axle clearance.
- Removal of plating to facilitate soldering motor in position.
- Oilite hole may be centered.
Oilite type bushings only - may be soldered and/or glued in position.
Magnets must be original type for setup and may only be located by original retainers. A small
amount of clue is permissible to stop fore and aft movement of magnet in can.
Magnets may be remagnetised.
Any motor brushes may be used with the exception of pre-shunted brushes.
Any brush springs may be used.
Shunt wire and spring insulation are prohibited.
Permitted armatures - any Parma, PSE, Proslot, RJR or Slotworks Super 16D armature with a minimum stack length of .450" and a minimum diameter of .520", wound with a minimum of 60 series wound turns of 28 gauge (AWG)
Armature spacers and commutator truing are permitted.

Return